| TROUBLESHOOTING | 25 |
|
|
|
|
|
PROBLEM | CHECK | CURE |
|
|
|
|
|
Burners burn with a yellow or orange flame, in | Inspect Spider/Insect Screens for possible obstructions. | Clean Spider/Insect Screens. (See Section “Annual |
|
conjunction with the smell of gas (This is normal | (Blockage of holes.) | Maintenance”) |
|
for the burner lighting tube). |
|
|
|
|
|
|
|
Symptoms: | The excess flow safety device, which is part of the | To reset the excess flow safety device turn all burner control |
|
Burners do not light. | barbecue to cylinder connection, may have activated. | knobs and the cylinder valve off. Disconnect the regulator |
|
flickering flame in the “HI” position. |
| from the cylinder. Turn burner control knobs to “HI”. Wait at |
|
Barbecue temperature only reaches 250˚ to 300˚ |
| least 1 minute. Turn burner control knobs to “OFF”. Reconnect |
|
in the “HI” position. |
| the regulator to the cylinder. Turn cylinder valve on slowly. |
|
|
| Refer to “Lighting Instructions”. |
|
|
|
|
|
Burner does not light, or flame is low in “HI” | Is LP fuel low or empty? | Refill LP cylinder. |
|
position. |
|
|
|
Is fuel hose bent or kinked? | Straighten fuel hose. |
| |
|
| ||
|
|
|
|
| Does Burner light with a match? | If you can light Burner with a match, then check the |
|
|
| Crossover® ignition system. |
|
| Did you use the snap igniter several times until the main | Make sure to hold the control knob in for two seconds after |
|
| burner lit (See Lighting Instructions)? | snapping the igniter and seeing the orange flame from the |
|
|
| burner lighting tube. |
|
|
|
|
|
| Does the igniter work? (Do you see a spark when you | Try manually lighting the burner (refer to “Main Burner |
|
| repeatedly use the snap igniter?) | Manual Lighting”). Call customer service. |
|
|
|
|
|
Experiencing | Are you preheating barbecue in the prescribed manner? | All burners on HI for 10 to 15 minutes for preheating. |
|
|
|
|
|
| Are the cooking grates and Flavorizer® bars heavily | Clean thoroughly. (See Section “Cleaning”) |
|
| coated with |
|
|
|
|
|
|
CAUTION: Do not line the bottom tray | Is the bottom tray “dirty” and not allowing grease to flow | Clean bottom tray. |
|
into catch pan? |
|
| |
with aluminum foil. |
|
| |
|
|
| |
|
|
|
|
Burner flame pattern is erratic. Flame is low when | Are burners clean? | Clean burners. (See Section “Maintenance”.) |
|
burner is on “HI”. Flames do not run the whole |
|
|
|
length of the burner tube. |
|
|
|
|
|
|
|
Inside of lid appears to be “peeling.” (Resembles | The lid is porcelain enamel or stainless steel, not paint. | Clean thoroughly. (See Section “Cleaning”.) |
|
paint peeling.) | It cannot “peel”. What you are seeing is baked on grease |
|
|
| that has turned to carbon and is flaking off. |
|
|
| THIS IS NOT A DEFECT. |
|
|
|
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
OPERATING THE HANDLE LIGHT
The Weber Grill Out™ Handle Light has a
HANDLE LIGHT TROUBLESHOOTING
PROBLEM | CHECK | CURE | |
|
|
| |
Weber Grill Out™ Handle | Are the batteries old? | Replace batteries. | |
Light does not light. |
|
| |
Are the batteries installed correctly? | See assembly illustration. | ||
| |||
|
|
| |
| Is the lid in the up position with the power button ON? | Light will activate when lid is open. | |
|
|
| |
| Is the Weber Grill Out™ Handle Light activated? | Press the power button. | |
| Is the Weber Grill Out™ Handle Light positioned correctly on the handle? | Adjust position (See assembly illustration). |
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
WWW.WEBER.COM®
