MAINTENANCE
WARNING: Disconnect power source before performing maintenance.
GENERAL RECOMMENDATIONS
The warranty on this unit does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, the operator must maintain unit as instructed in this manual. Various adjust- ments will need to be made periodically to properly maintain your unit.
BEFORE EACH USE
CHECK FOR LOOSE
FASTENERS AND PARTS
SHousing Screws S Assist Handle S Debris Shield
S Edge Guide
CHECK FOR DAMAGED OR WORN PARTS
Contact an authorized service dealer for re- placement of damaged or worn parts.
STrigger Switch
ger switch. Make sure motor stops.
SDebris Shield
AFTER EACH USE
INSPECT AND CLEAN UNIT AND DE- CALS
SAfter each use, inspect complete unit for
loose or damaged parts. Clean the unit us- ing a damp cloth with a mild detergent.
SWipe off unit with a clean dry cloth.
SERVICE AND ADJUSTMENTS
REPLACING THE LINE
SReplacement spools are
the existing spool.
NOTE: Always clear dirt and debris from cut- ting head components when performing any type of maintenance.
SHold spool and unscrew cap by turning in
the direction shown on top of the cap.
SRemove line guide ring and spool.
Feed line in direction shown on spool.
Spool
Cap
Line guide ring
Spool
2.Insert one end of line into center cavity of empty spool. Ensure line will feed into spool in the direction shown on the spool (counterclockwise).
3.Continue feeding line into spool, leaving 4
INSTALLING SPOOL WITH LINE
Use a
REFILLING THE SPOOL WITH LINE
WARNING: Use only 0.065 inch (1.65 mm) diameter round line. Other sizes and shapes of line will not advance properly and will result in improper cutting head func- tion or can cause serious injury. Do not use other materials such as wire, string, rope, etc. Wire can break off during cutting and become a dangerous missile that can cause serious injury.
1.Cut a length of 25 feet of 0.065 inch (1.65
mm)diameter round WEED EATER
brand line.
1.Install replacement spool.
2.Thread line through line guide ring.
Line through guide ring
Slot
Replacement Spool
3.Rest guide ring on spool and place line in slot. Allow line to extend 4
4.Ensure line remains in slot while screwing cap on to the shaft. Only tighten cap hand tight!
7