8
POWER CORD
ThePOWER CORDis whereyou attach y our
extension cord to the unit.
TRIGGERSWITCH
TheTRIGGERSWITCHisusedtoturnonthe
unit.Squeeze the trigger s witch to operate the
unit. Release to stop.
LINELIMITER PIN
TheLINE LIMITE R PIN cuts thecutting line t o
the proper cutting length.
TRIMMER HEAD
The TRIMMER HEAD holds cutting line and
rotates during operation.
OPERATING INSTRUCTIONSUse only a voltage supply as s pecified on
your unit.
SELECTAN EXTENSION CORD
ExtensionCord Gauge Chart
Length ofCord Gauge
25 Ft.(7.5 m)
50 Ft.(15 m)
100 Ft.(30 m)
18 Gauge
16 Gauge
16 Gauge
Extension cords are available for this unit.
ATTACHTHE EXTENSION
CORD TOYOUR TRIMMER
1. Form a loop in your extension cord.
2. Push the loop through the slot in the han-
dle( see illustration).
3. Position the loop over the cord ret ainerand
pull back to secure.
4. Connect power cord of unit to ext ension
cord.
CORRECT OPERATINGPOSITION
Trimming Edging
WARNING : Alwayswearey e protec-
tion. Never lean over the trimmer head.
Rocks or debris can ric ochet or be throw n into
eyes and face and cause blindness or other
serious injury.
When operating unit, stand as shown and
check for the following:
SWearey e protection and heavy clothing.
SHoldtrigger handle with right hand and as-
sist handle with left hand.
SKeep unit below waist level.
SCut only from your right to your left to en-
sure debris is thrown away from you. With-
outbending over, keep line near and paral-
lel to the ground and not crowded into
material being cut.
AUTOMATICLINE FEED SYSTEM
When the trimmer is initially started, a small
length of cutting line is fed out.
Line Limiter Pin
Afterapproximately 5seconds , the line will be
cut to the correct length by the line limiter pin
as the motor reaches full speed. Makesure
the motor is up to full speed before trim-
ming. If the noise of the cutting line being cut
cannot be heard, more line will need to be fed
out.
Tofeed more line:
SAllowthe motor to stop c ompletely; then, re-
start the motor and allow it to reach full
speed.