SCharge continuously when not in use. Con- tinuous charging will not damage the bat- tery. The charger will automatically keep the battery charged and ready for use dur-
ing storage.
S During charging, the charger becomes warm. This is normal and means the char- ger is operating correctly.
TO CHARGE YOUR UNIT:
1.Place the trimmer in the wall bracket.
2.Plug the charger into a standard house- hold electrical outlet.
3.When properly connected, the red charge indicator light (LED) will glow.
NOTE: The red charge indicator light (LED) on the charger glows continuously during charging.
4.The battery will be fully charged in 24 hours.
RECHARGING YOUR UNIT
SRecharge the battery as soon as the cutting
power of your cordless trimmer is no longer effective.
S Avoid running the battery into full dis- charge, i.e. avoid draining the battery com- pletely.
S Follow the procedure outlined in the CHARGING YOUR UNIT section.
SRecharging the battery according to these instructions should ensure maximum bat-
tery life.
SDo not recharge the battery in an area of ex- treme heat or cold. It will work best at nor- mal room temperature.
CORRECT OPERATING POSITION
SCut only from your right to your left to en- sure debris is thrown away from you. With- out bending over, keep line near and paral- lel to the ground and not crowded into material being cut.
ADVANCING THE CUTTING LINE
The cutting head advances line automat- ically. Do not tap head on the ground to advance line. This may break parts and cause cutting head to malfunction.
Always keep the shield in placewhen the tool is being operated.
Shield
Line Limiter Pin
After approximately 5 seconds, the line will be cut to the correct length by the line limiter pin as the motor reaches full speed. Make sure the motor is up to full speed before trim- ming. If the noise of the cutting line being cut cannot be heard, more line will need to be fed out.
To feed more line:
SAllow the motor to stop completely; then, re- start the motor and allow it to reach full speed.
SRepeat until you hear the line hitting against the line limiter pin (do not repeat this proce- dure more than 6 times).
If problems are experienced with the auto- matic line feed, refer to the TROUBLE-
SHOOTING TABLE.
To manually feed the nylon line:
SIf required, the cutting line can be fed out manually.
STo operate, press and release manual line feed button while gently pulling on one of the line until it reaches the line limiter pin.
TrimmingEdging
WARNING: Always wear eye protec- tion. Never lean over the trimmer head. Rocks or debris can ricochet or be thrown into eyes and face and cause blindness or other serious injury.
When operating unit, stand as shown and check for the following:
SWear eye protection and heavy clothing. S Hold trigger handle with right hand and as-
sist handle with left hand.
S Keep unit below waist level.
Manual Line
Feed Button
SIf the line extends past the line limiter pin, too much line has been fed out. If too much line is fed out, remove the spool cap and click spool counterclockwise until the line is at the desired length.
9
