USING YOUR UNIT
KNOW YOUR ELECTRIC BLOWER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations to your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
ON/OFF Switch | Variable Speed Control | |
|
| Collection Bag |
Cord | Air Vents |
|
Retainer |
| Elbow |
|
| Tube |
Rear | Upper Vacuum Tube | |
Handle | Retaining Post |
|
Inlet Cover |
| Vacuum Assist Handle |
Latch |
| |
|
| |
|
| Upper Vacuum Tube |
Tube Release Button |
| |
| Blower Tube |
|
|
| Lower Vacuum Tube |
Inlet Restrictor |
|
|
ON/OFF SWITCH |
| TUBE RELEASE BUTTON |
The ON/OFF SWITCH is used to activate | The TUBE RELEASE BUTTON secures the | |
the motor. |
| blower tube or elbow tube to the blower |
INLET COVER LATCH |
| unit during operation. Also, pressing the |
The INLET COVER LATCH is used to open | tube release button allows removal of the | |
and close the inlet cover and to secure | blower tube or elbow tube. | |
the upper vacuum tube to the blower | VARIABLE SPEED CONTROL | |
unit. |
| |
| The VARIABLE SPEED CONTROL is de- | |
BLOWER TUBE |
| |
| signed to allow an increase or decrease | |
The BLOWER TUBE is designed to direct | in motor speed as necessary during | |
the flow of air. |
| blower use only. To avoid causing dam- |
INLET RESTRICTOR |
| age to the unit, DO NOT attempt to use |
The INLET RESTRICTOR improves the | the variable speed control during vacu- | |
blower function. |
| um use. |
WARNING: You MUST make sure the tubes are secure before using the unit.
SWITCH POSITIONS
WARNING: Do not use the unit without the tubes or collection bag proper- ly attached to avoid flying debris and/or impeller contact which can cause serious injury. Always wear eye protection to pre- vent rocks or debris from being blown or ricocheting into the eyes and face which can result in blindness or serious injury.
STOPPING YOUR UNIT
To stop your unit, slide the ON/OFF switch to the OFF position.
OFF VARIABLE HIGH
SPEED SPEED
STARTING YOUR UNIT
Your unit has two run positions, HIGH (high speed) and VAR (variable speed). Slide the switch to one of these positions to turn on the unit.
8