Service and Adjustments, Replacing the Line

SERVICE AND ADJUSTMENTS

1.Remove spool by firmly pulling on tap button.

2.Clean entire surface of hub and spool.

3.Replace with a pre-wound spool, or cut two lengths of 12-1/2 feet (3,8 meters) of 0.080″ (2 mm) diameter WEED EATER brand line.

WARNING: Never use wire, rope, string, etc., which can break off and become a dangerous missile.

4.Insert ends of the lines about 1/2 inch (1 cm) into the small holes on the inside of spool.

Spool

Small

Holes

Line exit holes

Line in Notch

Hub

5.Wind the line evenly and tightly onto the spool. Wind in the direction of the ar- rows found on the spool.

6.Push the lines into the notches, leaving 3 to 5 inches (7 -- 12 cm) unwound.

7.Insert the lines into the the exit holes in the hub as shown in the illustration.

8.Align the notches with the line exit holes.

9.Push spool into hub until it snaps into place.

10.Pull the lines extending outside of the hub to release the lines from the notch- es.

WARNING: Perform the following steps after each use.

S Stop the unit and disconnect the power source when not in use.

SCarry the unit with motor stopped.

SAllow motor to cool before storing or trans- porting.

SStore unit and extension cord indoors in a high, dry place out of the reach of children.

Store unit unplugged.

SStore unit with all guards in place and position unit so that any sharp object cannot acciden- tally cause injury.

Prepare your unit for storage at the end of the season or if it will not be used for 30 days or more.

If your unit is to be stored for a period of time:

SClean it thoroughly before lengthy storage. S Store in a clean dry area.

S Lightly oil external metal surfaces and guide bar.

S Oil the chain and wrap it in heavy paper or cloth.