Make adjustments with the unit supported so the cutting attachment is off the ground and willnot make contact with any object. Holdthe unit by hand while runningand makingadjust- ments. Keep all parts of your body away from the cutting attachment and muffler.

To adjust idle speed:

Start engine and allow to warm up 4--5 minutes while heavy cutting, or 10--15 minutes moderate cutting. Allow engine to idle. Adjust speed until engine runs without stalling (idle speed too slow).

S Turn idle speed screw clockwise to in- creaseenginespeedif enginestalls or dies.

STurn idle speed screw counterclockwise to decrease engine speed.

Idle Speed Screw

If you require further assistanceor areunsure about performing this procedure, contact an authorized service dealer or call 1--800--554--6723.

STORAGE

CAUTION: Perform the following steps af- ter each use:

SAllow engine to cool, and secure the unit before storing or transporting.

SStore unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci- dentally cause injury.

SStore unit and fuel well out of the reach of children.

SEASONAL STORAGE

Prepare unit for storage at end of season or if it will not be used for 30 days or more.

If your unit is to be stored for a period of time:

SClean the entire unit before lengthy storage.

SStore in a clean dry area.

SLightly oil external metal surfaces.

FUEL SYSTEM

Under FUELING ENGINE in the OPERA- TION section of this manual, see messagela- beled IMPORTANT regarding the use of proper fuel in your engine.

Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to the gasoline in the fuel tank or fuel storage container.

Follow the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabilizer.

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through the spark plug opening. Slowly pull the starter rope 8 to 10 times to distribute oil.

SReplace spark plug with new one of recom- mended type and heat range.

SClean air filter.

SCheck entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having theproper gasolineto oil ratio.

OTHER

SDo not store gasoline from one season to another.

SReplace your gasoline can if it starts torust.

13

Page 13
Image 13
Weed Eater W25CB manual Seasonal Storage, Fuel System, Engine, Other