Installation
20 800032-01 Rev. G www.wegener.com
Table 2.1: Rear panel Connectors
Connector
Designation Type Pin Signal Name
ALARM/CUEING 10-pin male header
(mates to removable
terminal-strip)
1
(on left as viewed
from rear of unit)
OK (COM closes here when OK)
2COM:
3Alarm (COM closes here on alarm or if
power is off)
4 GND
5Cue Relay #1: N.C. contact
6Cue Relay #1: Common contact
7Cue Relay #1: N.O. contact
8Cue Relay #2: N.C. contact
9Cue Relay #2: Common contact
10 Cue Relay #2: N.O. contact
DTMF
(where available) 3-pin male header
(mates to removable
terminal-strip)
1 (on left as viewed
from rear of unit) DTMF tone, non-inverted output
2 GND
3DTMF tone, inverted output
AUDIO
(same for both
ports 1 and 2)
6-pin male header
(mates to removable
term strip)
1 (on left as viewed
from rear of unit) Right ‘+’
2Right GND
3Right ‘-’
4Left ‘+’
5Left GND
6Left ‘-’
COMPOSITE VIDEO
OUT BNC Jack Composite Video Out
SERIAL CONTROL RS232, 9-pin D
female jacks 1DCD (internally pulled to +5V)
2RxD (data output)
3TxD (data input)
4DTR (not connected)
5 GND
6DSR (internally pulled to +5V)