Wegener Communications DTV742 3rd-level Tuner Enable, 3rd-level Channel Number Selection

	Main-level Screens		Second-level Screens
Input Setup		2nd-level RF Input
Input	Setup ...	RF	Input X
		Where X is the RF port number.
		Press ENT to go to the third-level Input Setup Screens below and
Press the ENT key to bring up the second-level Program		use the 5 or 6keys to select <ON> or <OFF>, adding or
		removing this program to/from the output stream. Press ENT
Input screen.
		again to confirm.
Press the 4 key to go to Program Status.
		Press the 4 key to go to the next RF Input screen (1 through 4).
Press the 3 key to go to Clear Errored Seconds (if counter is
		Press the ESC key to return to the Input Setup screen.
non-zero) or Alarms/Warnings.
Press the ESC key to go to the Home Screen.			3rd-level Tuner Enable
		Tuner Enable:
		ON
		Press the ENT key to toggle between ON and OFF, enabling or
		disabling the tuner.
		Press the 4 key to go to the Channel Number Selection screen.
		Press the ESC key to return to the second-level RF Input screen.
		3rd-level Channel Number Selection
		Channel Number: XX
		Where XX is the current channel number.
		Press ENT to enter the edit mode and use the 5 or 6keys to
		change the channel number. Press ENT again to confirm your
		selection or ESC to cancel changes.
		Press the 4 key to go to the RF Standard screen.
		Press the 3 key to go to the Tuner Enable screen.
		Press the ESC key to return to the second-level RF Input screen.
		RF	3rd-level RF Standard
			Standard:
		Broadcast
		Press ENT and use the 5 or 6keys to toggle the RF Standard
		between Broadcast and Cable. Press ENT again to confirm your
		selection or ESC to cancel changes.
		Press the 3 key to go to the Channel Selection screen.
		Press the ESC key to return to the second-level RF Input screen.

800057-02 Rev. A Page 3 of 11 May 24, 2003