PROBLEM:
Next, locate the Reed Switch (20) and the Magnet (12) on the left side of the Pulley (11). Turn the Pulley until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet and the Reed Switch is about 1/8 in. (3 mm). If neces- sary, loosen the indicated Screw (29), move the Reed Switch slightly, and then retighten the Screw. Then, reattach the hood, and run the treadmill for a few min- utes to check for a correct speed reading.
The walking belt slows when walked on
Top |
|
View | 1/8 in. |
29 | |
20 | 11 |
12 |
SOLUTION:
PROBLEM:
SOLUTION:
a. Use only a
b. If the walking belt is overtightened, treadmill perfor- b mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both rear roller bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 3 to 4 in. (8 to 10 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
c.If the walking belt still slows when walked on, please see the front cover of this manual.
The walking belt is
a. If the walking belt is |
|
|
|
UNPLUG THE POWER CORD. If the walking belt |
| a |
|
has shifted to the left, use the hex key to turn the |
|
|
|
|
|
| |
left rear roller bolt clockwise 1/2 of a turn; if the walk- |
|
|
|
ing belt has shifted to the right, turn the left rear |
|
|
|
roller bolt counterclockwise 1/2 of a turn. Be careful |
|
|
|
not to overtighten the walking belt. Plug in the power |
|
|
|
cord, insert the key, and run the treadmill for a few |
|
|
|
minutes. Repeat until the walking belt is centered. |
|
|
|
|
|
| |
b. If the walking belt slips when walked on, first remove |
|
|
|
| b | ||
the key and UNPLUG THE POWER CORD. Using |
| ||
the hex key, turn both rear roller bolts clockwise, 1/4 |
|
|
|
of a turn. When the walking belt is correctly tightened, |
|
|
|
you should be able to lift each edge of the walking |
|
|
|
belt 3 to 4 in. (8 to 10 cm) off the walking platform. Be |
|
|
|
careful to keep the walking belt centered. Then, plug |
|
|
|
in the power cord, insert the key, and carefully walk |
|
|
|
on the treadmill for a few minutes. Repeat until the |
|
|
|
walking belt is properly tightened. |
|
|
|
27
