Weider 160xtb user manual Assembly

ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call 1-800-445-2480.

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex key		and your own Phillips screwdriver	. For help
identifying the assembly hardware, see the drawings below. The number in parentheses below each drawing
is the key number of the part, from the PART LIST near the end of this manual. The number following the paren-
theses is the quantity needed for assembly.	Note: Some small parts may have been preassembled. If a part is

not in the parts bag, check to see if it has been preassembled. To avoid damaging plastic parts, do not use power tools for assembly.

Star Washer	3/4" Screw (4)–4
(90)–10
Handrail Bolt (64)–6	Upright Bolt (72)–4

1. Make sure that the power cord is unplugged.	1
With the help of a second person, raise the front
of the treadmill and insert the crossbar on the
Base (83) into the cutout in the cardboard stand
as shown. Have the second person hold the
treadmill to prevent it from moving forward
or backward until assembly step 2 is com-
pleted.WARNING: Serious injury
may occur if the treadmill moves for-
ward or backward and falls off the card-
board stand. A second person must
hold the treadmill until assembly step 2	83
is completed to prevent the treadmill		Cardboard
from moving, tipping, or falling.
		Stand
	7