23.Press a 1” Round Inner Cap (41) into each end of a Spotter Tube (4).
Press a 1” Round Inner Cap into each end of the other Spotter Tube (not shown).
24.Insert a Spotter Tube (4) through a Front Upright (18) and into a Rear Upright (19). Rotate the Spotter Tube so that the hook locks in place around the Front Upright.
Insert the other Spotter Tube through the other Front and Rear Upright (not shown) in the same manner. Be sure that the Spotter Tubes are inserted at the same level on both sides.
25.Attach the indicated Handle (27) to one of the Cables (51) by inserting the hook on the end of the Handle through the loop in the end of the Cable.
Attach the other Handle to the other Cable (not shown) in the same manner.
23 |
4 |
41 |
41 |
24 |
18 |
19 |
4 |
25 |
Loop |
51 |
Hook |
27 |
26. Make sure that all parts are properly tightened before you use the weight bench.
13