Weider 831.150471 user manual

3.Press 20mm x 40mm Inner Caps (44) into the ends of both Backrest Tubes (25).

Lubricate an M10 x 152mm Bolt (11). Attach the Backrest Tubes (25) to the Bench Frame (49) with the Bolt and an M10 Nylon Locknut (14). See the inset drawing. The indicated hole in the Backrest Tube (25) is slightly off center. The Backrest Tube must be oriented as shown, when it is attached to the Bench Frame (49). Do not overtighten the Nylon Locknut; the Backrest Brackets must be able to move freely.

4.Slide the Adjustment Bracket (26) onto the Bench Frame (49). See the inset drawing. The guide rod inside the Adjustment Bracket must be on the indi- cated side of the welded tube in the Bench Frame.

Align one set of holes in the Adjustment Bracket

(26)with the hole in the Bench Frame (49). Insert the “L” Pin (46) through the Adjustment Bracket and the Bench Frame.

Lubricate an M10 x 152mm Bolt (11). Attach the Adjustment Bracket (26) to the Backrest Tubes (25) with the Bolt, two Adjustment Bracket Spacers (50), and an M10 Nylon Locknut (14). Do not overtight- en the Nylon Locknut; the Backrest Brackets and Adjustment Bracket must be able to move freely.

5.Attach the Backrest (29) to the Backrest Tubes (25) with four M6 x 48mm Screws (35) and four M6 Washers (42). Note: Before you attach the Backrest to the Backrest Tubes, look at the back side of the Backrest. You will notice that one set of threaded holes is closer to the end of the Backrest (see the inset drawing). This end of the Backrest must be closest to the Bench Frame (49).

6.Attach the Seat (34) to the Bench Frame (49) with the M6 x 60mm Screw (16), two M6 x 16mm Screws (17), and three M6 Washers (42).

7

3	44		25
		44		Hole must
				be on the
14			49	lower side
	25
	11—Lubricate
44
	49
4	Lubricate—11		Guide
	14		Rod
25		50		46
			49
			26	Welded
				Tube
26		49
		46
5
29		25
		42
		35
49			This end of the
	42		Backrest must
			be closest to the
	35		Bench Frame
6
	34
	49
			42
	42	17
	16