ASSEMBLY
Before beginning assembly, carefully read the following information and instructions:
•Assembly requires two people.
•Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•For help identifying the small parts used in assembly, use the PART IDENTIFICATION CHART attached at the center of the manual.
•As you assemble the weight bench, be sure that all parts are oriented as shown in the drawings.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY:
•Two (2) adjustable wrenches 
•One (1) rubber mallet 
•One (1) standard screwdriver 
•One (1) phillips screwdriver 
•Lubricant, such as grease or petroleum jelly, and soapy water will also be needed.
Assembly will be more convenient if you have the following tools: A socket set, a set of
1.Before assembling this product, be sure that you have read and understand the information in the box above.
Press a 50mm Square Outer Cap (40) onto each side of the Stabilizer (33).
Attach the Stabilizer (33) to the Bench Frame (49) with two M8 x 68mm Bolts (8), two M8 Washers (13) and two M8 Nylon Locknuts (12).
2.Press a 50mm Square Inner Cap (36) into each end of the Front Leg (22).
Attach the Front Leg (22) to the Bench Frame (49) with two M8 x 68mm Bolts (8), two M8 Washers (13) and two M8 Nylon Locknuts (12).
1 |
|
|
| 40 |
|
|
| 13 |
|
| 12 |
49 | 8 | 33 |
| 40 | |
|
| |
2 |
|
|
36 |
|
|
13 |
|
|
| 8 | 49 |
|
| |
12 |
|
|
36 | 22 |
|
|
|
6
