Assembly
Before beginning assembly, carefully read the following information and instructions:
•Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•For help identifying the small parts used in assembly, use the PART IDENTIFICATION CHART on the page 5.
•As you assemble the weight bench, be sure that all parts are oriented as shown in the drawings.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY:
•Two (2) adjustable wrenches 
•One (1) rubber mallet 
•One (1) standard screwdriver 
•Lubricant, such as grease or petroleum jelly plus soapy water.
Assembly will be more convenient if you have the following tools: A socket set, a set of
1.Before assembling this product, be sure that you have read and understand the information in the box above.
Position the Crossbar with the warning decal facing up as shown. Attach the Crossbar (3) to Upright A
(1)with two M10 x 70mm Bolts (26), a Support Plate (14) and two M10 Nylon Locknuts (30). The
Upright must be oriented as shown.
Attach the Crossbar (3) to Upright B (15) in the same manner.
2.Attach the Front Leg (8) to the Frame (2) with three M8 x 16mm Bolts (28) and three M8 Washers (17).
1 |
|
| 1 |
|
|
| |
26 | 14 |
| 15 |
|
|
| |
|
|
| 30 |
|
|
| 14 |
|
|
| 3 |
|
|
| 26 |
2 |
|
|
|
|
| 28 | 2 |
|
|
| |
|
|
| 17 |
|
|
| 17 |
|
|
| 28 |
|
| 8 |
|
6
