CABLE ASSEMBLY
33.Attach the High Cable (86) to a Small “U” Bracket (32) with a 1/4” Nylon Locknut (44) and a 1/4” Washer (37). Do not completely tighten the Nylon Locknut. It should be threaded onto the end of the Cable so only a couple of threads are showing above the Nylon Locknut, as shown in the inset drawing.
Attach the Small “U” Bracket (32) to the indi- cated Weight Tube (25) with a 5/16” x 1 3/4” Bolt (68) and a 5/16” Nylon Locknut (40).
34.Locate the Rear Cable
Locknut; the Pulley should turn easily. Make sure that the Cable is between the Pulley and the post, and that the Pulley Covers are turned so the wide tabs are on the indicated side.
35.Wrap the Rear Cable (87) around a 3 1/2” Pulley (82). Attach the Pulley and two Pulley Covers (62) to the Ab Upright (1) with a 3/8” x 4” Bolt (76), two 3/8” Washers (38) and a 3/8” Nylon Locknut (42). Do not overtighten the
Nylon Locknut; the Pulley should turn eas- ily. Make sure that the Cable is between the Pulley and the post.
33 |
|
|
|
|
| 86 |
|
| 32 | 40 |
|
|
|
| |
| 68 | 37 |
|
|
|
| |
|
| 44 |
|
|
| 25 | 86 |
|
|
| |
|
|
| 32 |
|
|
| 37 |
|
|
| 44 |
34 | Post |
|
|
| 76 |
|
|
| 38 | 82 |
|
|
|
| |
| 62 |
|
|
Wide Tabs | 87 | 38 42 | |
| must be |
| |
| on this |
|
|
| side |
|
|
| 1 |
|
|
35 |
| 1 |
|
| 76 |
| 87 |
|
|
| |
| 38 |
| 82 |
|
|
| 38 |
|
|
| 42 |
|
|
| 62 |
16
