Weider 831.159390 user manual Find the Press Cable 88. Attach the end

CABLE ASSEMBLY

45. Attach the Low Cable (89) to a Small “U”	45
Bracket (32) with a 1/4” Nylon Locknut (44)
and a 1/4” Washer (37). Do not completely
tighten the Nylon Locknut. It should be				89
threaded onto the end of the Cable so only
			32	40
a couple of threads are showing above the
			68
Nylon Locknut, as shown in the inset
drawing.				37
		89
	32			44
Attach the Small “U” Bracket (32) to the indi-
				25
cated Weight Tube (25) with a 5/16” x 1 3/4”		37
Bolt (68) and a 5/16” Nylon Locknut (40).
		44
46. Find the Press Cable (88). Attach the end of	46
the Press Cable (88) to the Large “U” Bracket
(84) with a 1/4” Nylon Locknut (44) and a 1/4”
Washer (37). Do not completely tighten the
Nylon Locknut. It should be threaded onto			44
the end of the Cable so only a couple of
threads are showing above the Nylon			37
Locknut, as shown in the inset drawing.				84
		44		88
		37
	88	84
47. Note: The 3 1/2” Pulley (82) in this step is	47
pre-assembled. It is shown dis-assembled
for easier part identification.
Route the Press Cable (88) around the 3 1/2”
Pulley (82) attached to the indicated bracket
on the Press Base (13). Be sure that the
Cable is in the groove of the Pulley and
that the Cable Trap (80) is turned as shown
to hold the Cable in place. Tighten the 3/8”
x 2” Bolt (50) and the 3/8” Nylon Locknut (42).
			88
			80	42
			82
		50	13

20