Weider 831.159821 user manual Ing Locate the Low Cable 47. Route the small ball, Locknut, Pulley

37.Attach the end of the Leg Lever Cable (96) to the other “U”-Bracket (85) with an M8 Washer (26)

and an M8 Nylon Locknut (71).	Note: Do not
completely tighten the Nylon Locknut; it
should be threaded only two turns onto the
end of the Cable, as shown in the inset draw-
ing.

38.Locate the Low Cable (47). Route the small ball

on the Cable through the cage on the Leg Press Frame (30).

Attach a 90mm Pulley (38) inside the Leg Press Frame (30) with an M10 x 70mm Bolt (81), two M10 Washers (75), two 13mm Spacers (34), and an M10 Nylon Locknut (70).

39.Route the Low Cable (47) through the Left Leg

(36)and the Left Upright (7). Attach a 90mm Pulley (38) inside the Upright with an M10 x 70mm Bolt (81), two M10 Washers (75), two 13mm Spacers (34), and an M10 Nylon Locknut

40.Wrap the Low Cable (47) around a 90mm Pulley

(38).Attach the Pulley and a Cable Trap (91) to the lower set of holes in the indicated “U”-Bracket

(85)with an M10 x 50mm Bolt (62) and an M10

Nylon	Locknut (70).	Be sure the Cable Trap is
turned	to hold the Cable in the groove of the
Pulley.

37
	96		96
	26
			71
85	71
38
		30
	38	34	70
			75
34			Cage
81	75		47
39
		34
38		75
		70
		47
		36
34
75	7
81
40
	85
	62	70
		91
	38
		47

16