Weider 831.159821 Tightening the Cables, Pulley move smoothly, Move smoothly, See drawing B

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight

system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the

cables should be tightened.

See drawing A. Slack can be removed by moving the 90mm Pulley (38) and Cable Trap (91) to a higher set of holes in a Double “U”-Bracket (56). Remove the

M10 Nylon Locknut (70) and the M10 x 50mm Bolt (62) from the Cable Trap, the Pulley, and the Double “U”- Bracket. Re-attach the Pulley and the Cable Trap to

the new set of holes in the Double “U”-Bracket with the

Bolt and Locknut. Make sure that the Cable Trap is in the proper position and that the Cable and

Pulley move smoothly.

Move the 90mm Pulley (38) in the other Double “U”-Bracket (56) in the same manner.

See drawing B. Slack can be removed by moving the 90mm Pulley (38) and the Cable Trap (91) to the high- er set of holes in a “U”-Bracket (85). Remove the M10 Nylon Locknut (70) and the M10 x 50mm Bolt (62) from the Cable Trap, the Pulley, and the “U”-Bracket. Re-attach the Pulley and the Cable Trap to the higher

set of holes in the “U”-Bracket with the Bolt and Locknut. Make sure that the Cable Trap is in the proper position and that the Cable and Pulley

move smoothly.

Move the 90mm Pulley (38) in the other “U”-Bracket (85) in the same manner.

See drawing B.	Slack can also be removed from the
cables by tightening the M8 Nylon Locknuts (71)
attaching a cable to either “U”-Bracket (85), or the
Small “U”-Bracket (79). To do this, you may need to
remove the 90mm Pulley (38) from the “U”-Bracket, or
remove the Small “U”-Bracket from the Weight Tube
(not shown). Make sure that the cables are not too tight
or the Top Weight (74) will be lifted off the weight stack.
ADJUSTING THE LEG PRESS PLATE
To adjust the Leg Press Plate (31), remove the Leg
Press Pin (87) from the Leg Press Frame (30) and the
Adjustment Tube (88). Move the Tube to the desired
position and secure it in place with the Pin.		Be sure
the Pin is turned to the locked position around the
Leg Press Frame.

A
		56
91		56
70		62
		38
B
	74		79
			85
70
	71
38
62
	74
		79
		30	31

22