ASSEMBLY
Make Things Easier for Yourself
Everything in this manual is designed to ensure that the weight system can be assembled suc- cessfully by anyone. However, it is important to realize that the versatile weight system has many parts and that the assembly process will take time. Most people find that by setting aside plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the following information and instructions:
•Assembly requires two people.
•As you assemble the weight system, make sure all parts are oriented as shown in the drawings.
•For help identifying small parts, use the PART IDENTIFICATION CHART in the center of this manual.
The following tools (not included) are required for assembly:
• two adjustable wrenches
• one rubber mallet
• one standard screwdriver
• one Phillips screwdriver
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•lubricant, such as grease or petroleum jelly, and soapy water.
Assembly will be more convenient if you have a socket set, a set of
FRAME ASSEMBLY
1.Before beginning assembly, be sure that you have read and understand the information in the box above.
Press a 50mm Square Inner Cap (27) into the end of the Base (4). Press a 50mm Square Outer Cap (51) onto each end of the Stabilizer (5).
Insert two M8 x 63mm Carriage Bolts (1) up through the Base (4). Insert two M8 x 67mm Carriage Bolts (14) up through the Stabilizer (5).
Note: Be sure the indents around holes in the Stabilizer are on the bottom.
Slide the bracket end of the Base (4) onto the M8 x 67mm Carriage Bolts (14) in the Stabilizer (5). Slide the Rear Upright (56) onto the Carriage Bolts. Hand tighten an M8 Nylon Locknut (3) onto each Carriage Bolt.
1 |
|
56 |
|
3 |
|
| 51 |
5 |
|
51 | 4 |
| |
Indents |
|
14 |
|
1 | 27 |
5
