
35.Attach the loop on the end of the Low Pulley Cable (75) to the indicated hole in the Small Leg Lever (41) with a 3/8” x 2 3/4” Bolt (46), two 3/8” Flat Washers (48), and a 3/8” Nylon Jamnut (63).
36.Remove a Pro Pulley (26) from the bag labeled “PULLEY BAG 2.
Identify the Press Cable (72). It is approximately 389 1/2” long and it has a ball on one end and a threaded shaft on the other. You will begin by attaching the end with the ball.
Wrap the Press Cable (72) around a Pro Pulley (26) in the direction shown. Attach the Pulley to the indicated hole in the Press Top Frame (9) with a 3/8” x 3 1/2” Bolt (56), a 3/8” Flat Washer (48), and a 3/8” Nylon Jamnut (63). Make sure the Cable is between the
Pulley and the welded pin on the Press Top Frame.
37.Route the threaded end of the Press Cable (72) around the 3 1/2” Pulley (24) that is already mounted on the Top Frame (9).
38.Wrap the Press Cable (72) around a 3 1/2” Pulley (24) in the direction shown. Attach the Pulley to the indicat- ed hole in the Press Upright (2) with a 3/8” x 3 3/4” Bolt (59), a 3/8” Flat Washer (48) and a 3/8” Nylon Locknut (50). Make sure the Cable Trap is oriented as shown.
35 |
|
41 |
|
63 |
|
48 | 75 |
| |
48 | 46 |
36 |
|
| 9 |
63 | 26 |
48 | 72 |
| 56 |
| Pin |
37 |
|
9 |
|
| 24 |
| 72 |
38 | 2 |
50 |
|
48 |
|
| 25 |
| 24 |
72 | |
| 59 |
16