Weider C670 user manual Right Safety Spotter not shown in the same Manner

26. Press a 50mm Square Inner Cap (13) and a	26	Lubricate
25mm Square Inner Cap (28) into the Right				80
		113
Butterfly Arm (56). Press two Plastic Butterfly
		79		97
Bushings (79) and two Metal Butterfly Bushings			28
(113) into the Arm. Wet the bottom of the Butterfly				55
Arm with soapy water and slide a Butterfly Foam
Pad (66) onto the Arm.		79
Lubricate a 1/2” x 78mm Bolt (97) and the Plastic		113	94	57
Butterfly Bushings (79) with grease. Attach the			Lubricate	80
Right Butterfly Arm (56) to the Butterfly Bracket		56
(55) with the Bolt and a 1/2” Nylon Locknut (94).
Cover the Bolt and Locknut with two Butterfly		13
Caps (80). Do not overtighten the Locknut; the
Butterfly Arm must be able to pivot easily.
Repeat this step with the Left Butterfly Arm		66
(57).
27. Press two Caps w/Holes (61) and two Handgrips	27
(59) onto the Dip Arm (60).		101
				Warning Decal
Attach the Dip Arm (60) to the Left Safety Spotter				60
(51) with two M10 x 97mm Carriage Bolts (101)
and two M10 Nylon Locknuts (34). Make sure				61
the warning decal is in the indicated location.
				59
Note: The Dip Arm (60) can be attached to the		34
Right Safety Spotter (not shown) in the same
manner.
	34			61
				59
		51
28. Attach the Butterfly Backrest (112) to the Center	28
Upright (45) with two M6 Washers (78) and two
M6 x 75mm Screws (96).
				96
				78
				45
				96
				78
	112
	15