3.Press a 2” Square Inner Cap (29) into the lower end of the Right Upright (9).
Attach the Right Upright (9) to the Right Base (7) with
a Support Plate (28), two M8 x 65mm Bolts (42) and two M8 Nylon Locknuts (40).
4.Insert an M8 x 55mm Carriage Bolt (47) through the front hole in each Base (6, 7). Slide the mounting bracket (B) on the Bench Frame (5) onto the Carriage Bolts. Partially tighten an M8 Nylon Locknut (40) onto
each Carriage Bolt. | Do not tighten the Nylon |
Locknuts yet. |
|
Insert two M8 x 60mm Bolts (48) through the mount- ing bracket (B) on the Bench Frame (5) and the Left
and Right Base (6, 7). Tighten an M8 Nylon Locknut
(40)onto each Bolt.
5.Press an Outer Upright Bushing (46) onto the top end of each Upright (8, 9).
Slide a Weight Rest (11) into the Right Upright (9). Align one of the holes in the Weight Rest with the hole in the Upright. Insert an M10 Adjustment Knob
(25)through the Upright and the Weight Rest. Tighten the Knob into the welded nut.
Insert the other Weight Rest into the Left Upright (8) in the same manner.
Both Weight Rests must be set at the same height.
6.Press a 1 1/4” Square Inner Cap (34) into each end of the Adjustment Tube (12).
Insert the Adjustment Tube into one set of adjustment brackets (C) on the Uprights (8, 9).
Make sure the Adjustment Tube (12) is oriented as shown and that the pins on the Tube are fully inserted into the slots in the adjustment brackets
(C).
Tighten all of the bolts and nylon locknuts used in steps 1 to 4.
7
3 |
|
|
|
| 9 |
|
| 42 |
40 |
| 28 |
7 |
|
|
|
| 29 |
4 |
|
|
5 | 40 |
|
| B | 48 |
|
| 7 |
6 |
|
|
40 | 47 |
|
5 |
|
|
| 11 |
|
11 |
|
|
| 46 |
|
8 |
| Welded Nut |
25 |
| |
|
| 9 |
6 |
|
|
34 |
|
|
| C |
|
| 12 |
|
|
| 34 |
8 |
|
|
| Pin | 9 |
|
|
