28.Attach the Backrest (69) to the Backrest Frames (78) with four M6 x 36mm Screws (62) and four M6 Washers (81). Make sure that the Backrest is oriented as shown. Do not tighten the Screws yet.
29.Lubricate an M10 x 180mm Bolt (76). Attach the Backrest Frames (78) to the Bench Frame (63) with the Bolt, two M10 Small Washers (6), and an M10 Nylon Locknut (11). Do not overtighten the
Nylon Locknut; the Backrest must be able to pivot freely.
Pull the Bench Knob (80) out as far as it will go. Slide the Backrest Bracket (53) into the indicated slot on the Bench Frame (63). Engage the Bench Knob into an adjustment hole in the Backrest Bracket.
Tighten the M10 Nylon Locknuts (11) and the M6 x 36mm Screws (62) used in steps 27 and 28.
30.Attach the Seat (68) to the Bench Frame (63) with four M6 x 16mm Screws (61). Make sure that the Seat is oriented as shown.
31.Press two 19mm Round Inner Caps (66) into each of the three Pad Tubes (88). Slide the Pad Tubes through the indicated holes in the Front Leg (73) and the Leg Lever (72).
Slide two Foam Pads (65) onto each Pad Tube (88).
28 |
| |
69 | 78 | |
Wide | 81 | |
End |
| |
81 | 62 | |
81 | ||
62 | ||
62 | ||
| ||
29 |
| |
Lubricate | 78 | |
| ||
6 |
| |
76 |
| |
80 |
| |
63 |
| |
53 | 6 11 | |
| ||
30 |
| |
Wide |
| |
End |
| |
68 |
| |
| 63 | |
| 61 | |
31 |
| |
65 | 73 | |
| ||
72 |
| |
65 | 66 | |
66 | ||
88 | ||
| ||
88 | 66 | |
66 | 65 | |
| ||
| 65 |
13
