16.Press a 30mm x 60mm Inner Cap (68) into the end of the Rack Stabilizer (44). Press a 25mm Round Inner Cap (23) into the Rack Stabilizer.
Attach the Rack Stabilizer (44) to the Rear Upright (49) with two M10 x 78mm Bolts (67), an M10 Washer (6), and two M10 Nylon Locknuts (11).
Tighten the M10 Nylon Locknuts (11) used in steps 13, 15, and 16.
17.Route the Cable (58) up through the Rear Frame (49) and around a Pulley (56), as shown. Attach the Pulley inside the Frame with an M10 x 75mm Bolt (66), two Long Spacers (69), two M10 Washers (6), and an M10 Nylon Locknut (11).
18.Wrap the Cable (58) around a Pulley (56). Attach the Pulley and a Cable Trap (57) to the bracket on the Rear Upright (49) with an M10 x 47mm Bolt (24) and an M10 Nylon Locknut (11). Be sure the Cable Trap is on the outside of the bracket and turned to hold the Cable in the groove of the Pulley.
19.Attach the Cable (58) to the M10 x 19mm Bolt (not shown) in the Weight Carriage (50) with an M10 Nylon Locknut (11).
16 |
|
|
|
|
|
|
| 23 | 68 |
|
|
|
| |
|
|
| 11 |
|
|
| 11 |
|
|
|
|
|
| 44 |
49 |
|
|
|
|
|
|
| 67 |
|
6 |
|
|
|
|
67 |
|
|
|
|
17 |
|
|
|
|
56 |
|
|
| |
6 |
|
|
|
|
11 |
|
|
|
|
69 |
|
|
|
|
58 |
| 6 | 49 |
|
|
|
|
| |
| 69 | 66 |
|
|
|
|
|
| |
18 |
|
|
|
|
58 | 11 | 57 | 56 |
|
|
|
|
| |
|
|
| 24 |
|
| 49 |
|
|
|
19 |
|
|
|
|
|
|
| 58 |
|
|
|
| 11 |
|
50 |
|
|
|
|
10
