ASSEMBLY
Make Things Easier for Yourself
This manual is designed to ensure that the weight bench can be assembled successfully by anyone. Most people find that by setting aside plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the following information and instructions:
•Assembly requires two people.
•For help identifying small parts, use the PART IDENTIFICATION CHART.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•As you assemble the weight bench, make sure all parts are oriented as shown in the drawings.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
The following tools (not included) are required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
•Lubricant, such as grease or petroleum jelly, and soapy water.
Assembly will be more convenient if you have a socket set, a set of
1.
Before beginning, make sure you under- stand the information in the box above. Note: Some parts described in the assem- bly steps may be
Press two 50mm Square Inner Caps (10) into the ends of the Stabilizer (2).
Attach the Stabilizer (2) to the Bench Frame (1) with two M10 x 58mm Carriage Bolts (32) and two M10 Nylon Locknuts (11). Do not tighten the
Locknuts yet.
Note: The indents around the holes in the Stabilizer (2) should be on the bottom, and the decal should be in the indicated location.
2.Press two 50mm Square Outer Caps (74) onto the ends of the Front Leg Base (4). Press a 50mm Square Inner Cap (10) into the top of the Front Leg
(3).
Attach the Front Leg (3) to the Front Leg Base (4) using the two Front Leg Plates (13), four M10 x 72mm Bolts (70), and four M10 Nylon Locknuts (11). Do not tighten the Locknuts yet.
1 | 1 | 11 |
|
| |
| 10 |
|
| 2 | Decal |
|
| |
| Indents |
|
| 32 | 10 |
|
| |
2 |
|
|
|
| 10 |
|
| 3 |
4 | 13 |
|
| 11 | |
|
| |
74 |
|
|
70 |
|
|
70 | 74 |
|
5
