Weider WEBE12622 user manual Tighten the M10 Nylon Locknuts 11 used in steps

3.Attach the Front Leg (3) to the Bench Frame (1) using two Small Joint Plates (34), four M10 x 68mm Bolts (31), and four M10 Nylon Locknuts (11).

Tighten the M10 Nylon Locknuts (11) used in steps 1–3.

4.Press three 45mm Square Inner Caps (26) into the Leg Lever (8). Press a 25mm Round Inner Cap (23) into the indicated end of the Weight Tube (9).

Attach the Weight Tube (9) to the Leg Lever (8) with an M8 x 58mm Bolt (38), two M8 Washers (41), a Short Spacer (39), and an M8 Nylon Locknut (73).

Press an Angled Outer Cap (25) onto the back end of the Weight Tube (9).

5.Lubricate an M10 x 68mm Bolt (31) with grease. Attach the Leg Lever (8) to the Front Leg (3) with the Bolt and an M10 Nylon Locknut (11). Do not overtighten the Locknut; the Leg Lever must be able to pivot easily.

6.Press four 25mm Square Inner Caps (27) into the ends of the Backrest Frames (33).

Attach the Backrest Bracket (5) to the Backrest Frames (33) with four M6 x 38mm Screws (37) and four M6 Nylon Locknuts (40). Make sure the

Backrest Frames are oriented so that the indi- cated holes are closer to the bottom. Do not tighten the Locknuts yet.

3
34	1
11
34
3		31
4
26
8
26
	41	25
73
39		41
23
9	26	38
5
11
8
3		31
		Lubricate
6		27
	33
37
		Holes
27	37
	40
40
5	40

6