14.See the inset drawing. Press two Carriage Bushings (52) into the top and bottom of the Weight Carriage (50). Press two 25mm Round Inner Caps (23) into the ends of the weight tube on the Carriage. Insert the M10 x 22mm Bolt (60) into the bracket on the Carriage from the side shown.
See the inset drawing. Press the Carriage Stop Bushing (72) into the Weight Stop (53).
Press two 60mm Square Inner Caps (22) into the ends of the Rear Upright (49).
Slide the Weight Carriage (50) onto the Rear Upright (49), as shown. Slide the Weight Stop
(53)onto the Rear Upright and secure it with an
M10 x 86mm Bolt (59) and an M10 Nylon Locknut
15.Attach the Rear Upright (49) to the Frame (43) with four M10 x 78mm Bolts (67), a Support Plate (61), and four M10 Nylon Locknuts (11). Do not tighten the Locknuts yet.
14 |
|
|
|
| 22 |
|
|
|
| 49 |
|
23 | 52 |
|
|
|
|
| |
| 50 | 50 |
|
|
|
| |
| 23 | 11 | 53 |
60 |
| ||
|
|
| |
52 |
|
| 59 |
|
|
| |
72 | 53 | 22 |
|
|
| ||
15 |
|
|
|
|
| 49 |
|
|
|
| 11 |
43 |
|
|
|
|
|
| 61 |
67 |
|
|
|
9
