ATTACHING WEIGHTS TO THE LAT TOWER
To use the Lat Tower (26), slide the desired amount of weight (not included) onto the weight tube on the Weight Carriage (32).
WARNING: Do not place more than 130 pounds on the weight carriage.
When performing an exercise during which you are sitting on the bench with your back to the lat tower, make sure there is plenty of space between your back and the weight car- riage. Always lower the weight carriage in a controlled manner. Never let the weight car- riage drop.
ADJUSTING THE UPRIGHTS
The Uprights (1) can be adjusted to five heights for different exercises. To adjust the height, remove the M10 x 67mm Adjustment Knobs (37) from both Uprights and Upright Bases (7). Slide the Uprights to the desired position and
WARNING: Always set both uprights at the same height. Make sure that the adjustment knobs are inserted completely and tightened into the uprights.
ATTACHING THE CURL POST
For some exercises, the Curl Post (27) must be attached to the weight bench.
Slide the Curl Post (27) into the Front Leg (8). Align one of the adjustment holes in the Curl Post with the adjustment hole in the Front Leg. Fully tighten the M10 x 48mm Adjustment Knob (41) into the adjust- ment hole in the Front Leg.
Note: When the Curl Post (27) is not in use, the 45mm Square Inner Cap (21) should be inserted into the Front Leg (8).
| 26 | |
| Weight | |
| Tube | |
| 32 | |
| Weight | |
37 | 1 | |
1 | ||
| ||
| 7 | |
| 37 | |
| 7 | |
| 21 | |
| 27 | |
| 41 | |
| 8 |
12
