10.Press four 19mm Round Inner Caps (24) into the ends of the two Pad Tubes (25).
Insert the Pad Tubes (25) into the holes in the Leg Lever (15). Slide two Foam Pads (23) onto each Pad Tube.
11.Attach the Seat (7) to the bracket on the Seat Frame (6) using two M6 x 16mm Bolts (31). Attach the other end of the Seat to the Seat Frame with an M6 Washer (19) and an M6 x 50mm Bolt (39).
12.Press a Square Bushing (16) into the top and bot- tom of a Weight Rest (12) and a Weight Spotter (11). Screw a Large Adjustment Knob (18) into the Weight Rest and the Weight Spotter.
Pull the Large Adjustment Knob (18) in the Weight Spotter (11) out as far as it will go. Slide the Weight Spotter over an Upright (4). Snap the Knob into one of the lower adjustment holes in the Upright. Turn the Knob clockwise until tight. Attach a Weight Rest (12) to the Upright in the same manner. Press an Upright Cap (17) into the top of the Upright.
Repeat this step with the other Upright (4).
Note: Make sure both Weight Rests (12) and both Weight Spotters (11) are set at the same height.
13.Make sure that all parts are properly tightened before you use the weight bench. The use of all remaining parts will be explained in ADJUST- MENTS on page 10.
10 | 23 |
|
|
| |
24 | 15 |
|
|
| |
23 |
|
|
| 23 |
|
| 25 | 24 |
|
| |
| 23 |
|
11 |
|
|
| 7 |
|
| 6 |
|
| 31 |
|
| 19 |
|
| 39 |
|
12 |
|
|
| 16 |
|
| 12 |
|
| 18 |
|
| 16 |
|
| 11 |
|
| 18 |
|
| 16 |
|
| 17 |
|
| 4 |
|
| Adjustment Hole |
|
9
