ATTACHING WEIGHTS TO THE LEG LEVER
To use the the Leg Lever (9) or Lat Tower (40), slide the desired amount of weight (not included) onto the weight tube on the Leg Lever or Weight Carriage (41). Secure the weight on the Weight Carriage with the two Weight Clips (52).
WARNING: Do not place more than 50 pounds on the Leg Lever (9).
ADJUSTING THE WEIGHT RESTS
To change the height of the Weight Rests (6), remove your barbell from the Weight Rests. Then, remove the Long Adjustment Knobs (27) from both Uprights (4, 5). Position the Weight Rests at the desired height, so that the holes in the Weight Rests and the Uprights are aligned. Fully tighten the Adjustment Knobs into the Weight Rests and the Uprights.
WARNING: The Long Adjustment Knobs (27) must be inserted through the Weight Rests (6) and the Uprights (4, 5) and be firmly tightened. Never tighten an Adjustment Knob into an Upright before inserting the Weight Rest. Always set both Weight Rests at the same height.
ATTACHING THE CURL POST
For some exercises, the Curl Post (13) or Lat Tower (not shown) must be attached to the weight bench.
Insert the Curl Post (13) into the indicated hole in the Front Leg (2). Align the holes in the Front Leg and the Curl Post. Secure the Curl Post with the Short Adjustment Knob (51). Make sure that you fully tight- en the Adjustment Knob.
The Lat Tower (not shown) can be attached to the Front Leg (2) in the same manner. Be sure that the Lat
Tower is oriented as shown on the front cover of this manual.
See the inset drawing. When the Curl Pad (17) is not in use, it can be stored in the tube on the Right Base (35).
| 40 |
| 41 |
52 |
|
9 |
|
Weight |
|
Tube | 52 |
| |
| 6 |
| 27 |
| 6 |
5 |
|
| 27 |
| 4 |
17 | 17 |
| 13 |
35 | 51 |
| |
| 2 |
11
