16.Make sure all parts are properly tightened before you use the weight bench. The use of all remaining parts will be explained in Adjusting the Weight Bench starting below.
Adjusting the Weight Bench
This section explains how to adjust the weight bench. See the EXERCISE GUIDELINES on page 13 for impor- tant information on how to get the most benefit from your exercise program. Also, refer to the accompanying exercise poster to see the correct form for each exercise.
Inspect and tighten all parts each time you use the weight bench. Replace any worn parts immediately. The weight bench can be cleaned with a damp cloth and a mild,
USING THE WEIGHT RESTS AND CURL BARBELL
Before beginning an exercise, move the Weight Rests
(21)and the Safety Spotters (26) to a set of holes in the Uprights that is best suited for that exercise. The selected holes should represent the lowest point to which you want your barbell to go during the exercise. Perform the exer- cise as shown in the accompanying EXERCISE GUIDE.
Note: Make sure the locking clips snap into place around the Uprights.
Important: The Safety Spotters (26) are engineered as a safety device. Their primary function is to minimize the risk of injury in case you drop the barbell during standing exercises. The Safety Spotters are deliber- ately designed to bend when hit with a barbell loaded with heavy weights. This is done to minimize the risk of the barbell jumping off the safety Spotters and causing potential injury to the user. If you accidental- ly bend the Safety Spotters, please call our Customer Service number (see the front cover) to order replace- ment Spotters.
WARNING: Always set both weight rests at the same height. Always set both safety spotters at the same height.
When you are not using the Curl Barbell (31), it can be stored in the Barbell Posts (35).
ADJUSTING THE FOAM PADS
The Foam Pads (10) on both the Leg Lever (18) and the Front Leg (19) can be adjusted to two different positions. To do this, pull one Foam Pad off the Pad Tube (38).
Move the Pad Tube to the other hole in the bracket on the Front Leg or in the Leg Lever. Push the Foam Pad back onto the Pad Tube.
1 |
21 |
Locking |
Clip |
26 |
31 |
35 |
Locking |
Clip |
Bracket |
38 |
18 |
10 |
19 |
11
