10.Press a 51.8mm x 76.2mm Inner Cap (24) into the top end of one Upright (1).
Press an Outer Cap (25) onto each end of one Base
(2).
Place the bracket on the lower end of the Upright (1) over the indicated holes in the Base (2).
Note: During the following steps, make sure the M10 x 68mm Bolts (33) are inserted from the direction shown in the drawing.
Attach the Upright (1) to the lower arm of the Base
(2)with two M10 x 68mm Bolts (33) and two M10 Nylon Locknuts (11). Do not tighten the Nylon
Locknuts yet.
Attach the Upright (1) to the bracket on the upper arm of the Base (2) with two M10 x 68mm Bolts (33) and two M10 Nylon Locknuts (11). Do not tighten the
Nylon Locknuts yet.
Note: Set the upright assembly aside so it cannot fall over. In step 13 this upright assembly will be mounted on the right side of the bench. See the drawing on page 4 to determine what is the right and the left side.
11.Press a 51.8mm x 76.2mm Inner Cap (24) into the top end of the remaining Upright (1).
Press an Outer Cap (25) onto each end of the remaining Base (2).
Place the bracket on the lower end of the Upright (1) over the indicated holes in the Base (2).
Note: During the following steps, make sure the M10 x 68mm Bolts (33) are inserted from the direction shown in the drawing.
Attach the Upright (1) to the lower arm of the Base
(2) with two M10 x 68mm Bolts (33) and two M10 Nylon Locknuts (11). Do not tighten the Nylon
Locknuts yet.
Attach the Upright (1) to the bracket on the upper arm of the Base (2) with two M10 x 68mm Bolts (33) and two M10 Nylon Locknuts (11). Do not tighten the
Nylon Locknuts yet.
Note: Set the upright assembly aside so it cannot fall over. In step 13 this upright assembly will be mounted on the left side of the bench.
10 | 24 |
| 1 |
| 33 |
| 25 |
| 33 |
| 11 |
| 11 |
| 11 |
| 2 |
25 |
|
11 | 24 |
| 1 |
| 11 |
| 25 |
| 11 |
| 33 |
| 2 |
25 | 33 |
9
