7.Attach the Backrest (15) to the Backrest Tubes (27) with four M6 x 52mm Screws (4) and four M6 Washers (30).
8.Attach the Seat (14) to the indicated brackets on the Bench Frame (5) with four M6 x 16mm Screws (3).
9.Press a 3/4Ó Round Inner Cap (12) into each end of the three Pad Tubes (38).
Slide a Foam Pad (10) onto one end of each Pad Tube (38).
Slide the Pad Tubes (38) into the indicated holes in the Leg Lever (18) and the bracket on the Front Leg (19). Slide another Foam Pad (10) onto the other end of each Pad Tube.
10.Press a 60mm x 60mm Square Inner Cap (9) into each end of the Left Base (2) and the Right Base (7). Place both bases on the floor and orient them as shown in the drawing.
Place the Rear Base (8) on the floor with the ends inside the brackets on the Left Base (2) and the Right Base (7). Secure the Rear Base with four M10 x 78mm Bolts (33) and four M10 Nylon Locknuts (11).
Note: Do not tighten the Nylon Locknuts yet.
7 | 15 |
|
|
|
|
| |
| 27 |
| 30 |
|
|
| |
|
|
| 4 |
| 30 | 30 |
|
|
| 4 |
|
8 |
|
|
|
| 14 |
|
|
|
|
| 5 |
|
| 3 |
|
|
| 3 |
|
9 | 10 | Bracket |
|
|
| 19 |
|
|
|
| 38 |
18 |
|
|
|
| 10 | 12 |
|
12 |
|
| 12 |
| 38 | 38 | 10 |
| 12 |
|
|
|
| 10 |
|
10 |
| 11 |
|
| 33 |
| 8 |
|
|
| |
| 7 | 9 | 11 |
|
| ||
|
|
| |
|
|
| 33 |
9 |
|
| 9 |
|
|
| |
|
| 9 | 2 |
8
