Weider WEBE96490 manual Assembly

Assembly

Before beginning assembly, carefully read the following information and instructions:

Make Things Easier for Yourself!

Everything in this manual is designed to ensure that the assembly of our products can be complet- ed successfully by anyone. However, it is impor- tant to recognize that your new equipment is a sophisticated product with many small parts and consequently, the assembly process will take time. Most people find that by setting aside plenty of time, and by deciding to make the task enjoy- able, assembly will go smoothly.

¥Assembly requires two people.

¥Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

¥Tighten all parts as you assemble them, unless instructed to do otherwise.

¥For help identifying the small parts, use the PART IDENTIFICATION CHART on page 5.

¥As you assemble the weight bench, make sure all parts are oriented as shown in the drawings.

The following tools (not included) are required for assembly:

¥ Two (2) adjustable wrenches

¥ One (1) rubber mallet

¥ One (1) standard screwdriver

¥ One (1) phillips screwdriver

¥Lubricant, such as grease or petroleum jelly plus soapy water.

Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches or a set of ratchet wrenches.

1.Before beginning assembly, make sure you have read and understand the information in the box above. Note: Some of the parts described in the assembly steps may come pre-assembled.

Press a 50mm x 50mm Square Inner Cap (17) into the indicated ends of the Front Leg (19).

Insert an M10 x 70mm Bolt (48) with an M10 Washer

(6)through the lower of the two holes in the Front Leg (19). Insert an M10 x 70mm Bolt with no Washer through the upper of the two holes in the Front Leg.

Slide the bracket on the Bench Frame (5) over the two M10 x 70mm Bolts (48) and secure it with two M10 Nylon Locknuts (11).

2.Press a 60mm x 60mm Square Inner Cap (9) into each end of the Stabilizer (37). Insert two M10 x 70mm Carriage Bolts (52) through the holes in the Stabilizer. Note that on one side of the Stabilizer there is an indentation around the holes. Push the Bolts in from this side, and then turn the bolt heads towards the floor.

Slide the bracket on the Bench Frame (5) over the two M10 x 70mm Carriage Bolts (52) in the Stabilizer (37) and secure it with two M10 Nylon Locknuts (11)

1	11
		5
48		11
	6
	19
17
2		11
	5
	9	37
		9
		52

6