9.Press two 38mm x 50mm Inner Caps (41) into the ends of the Cross Frame (11).
Orient the Cross Frame (11) as shown, with the welded tubes near the top. Attach the Cross Frame (11) to the Upright Base (3) with two M10 x 102mm Carriage Bolts (73), two M10 Washers (75), and two M10 Nylon Locknuts (76).
10.Press a 38mm x 50mm Inner Cap (41) into the top of the Front Leg (6). Press the Front Leg Foot (27) onto the bottom of the Front Leg. Note that the front of the Front Leg Foot slants more than the back.
Press a 38mm x 50mm Inner Cap (41) into the end of the Bench Frame (5).
Attach the Bench Frame (5) to the Front Leg (6) with two M10 x 53mm Carriage Bolts (61) and two M10 Nylon Locknuts (76).
11.Lubricate the M10 x 78mm Bolt (66). Attach the Bench Frame (5) to the Upright Base (3) with the Bolt and an M10 Nylon Locknut (76). Do not overtighten the Locknut; the Bench Frame must be able to pivot easily.
Tighten the Knob (30) into the Upright Base (3) and the Bench Frame (5).
12.Attach the Leg Lever Bumper (55) to the Front Leg (6) with the M4 x 19mm Screw (62).
Press two 45mm Square Inner Caps (42) into the ends of the Leg Lever (7).
Lubricate the M10 x 68mm Bolt (64). Attach the Leg Lever (7) to the Front Leg (6) with the Bolt and an M10 Nylon Locknut (76). Do not over- tighten the Locknut; the Leg Lever must be able to pivot easily.
9 | 76 | 75 |
| 41 |
|
|
| ||
|
|
|
| |
| 75 | 11 | 3 |
|
Welded |
|
| ||
Tube |
|
|
|
|
41 |
|
|
|
|
|
|
|
| 73 |
10 |
|
|
|
|
41 |
| 5 |
|
|
|
|
|
| |
|
|
| 41 | |
|
| 76 |
| |
|
|
|
| 6 |
|
|
|
| 61 |
|
|
|
| 27 |
11 | 3 |
|
|
|
|
|
|
| |
|
| 30 | Lubricate |
|
|
| 66 | 5 |
|
76 |
|
|
|
|
12 |
|
|
|
|
|
|
| Lubricate | |
|
|
| 6 | 64 |
|
|
| 42 | |
|
|
|
| |
|
| 76 | 55 | 7 |
|
| 62 | ||
|
|
|
| 42 |
8
