14.Route the Long Cable (18) around the remaining Cable Pulley (50). Slide the Cable Pulley into a Pulley Bracket (49) and secure it using an M10 x 27mm Bolt (51) and an M10 Nylon Locknut (42).
Attach the Large Cable Clip (36) and a Cord Ring (16) to the Pulley Bracket (49). Attach the Cord Ring to the hooks at the high pulley station.
15.Slide an M10 x 67mm Bolt (48) with an M10 Flat Washer (44) through the bottom set of holes in the Rail Leg (9). Make sure the Bolt is under the Short Cable (19). Secure the Bolt with an M10 Flat Washer (44) and an M10 Nylon Locknut (42).
Slide the Leg Lever Pulley (24) into the hole in the Rail Leg (9). Make sure the Short Cable (19) fits into the groove of the Leg Lever Pulley. Attach the Pulley to the Rail Leg (9) using an M10 x 67mm Bolt (48), two M10 Flat Washers (44), two 12.5mm Spacers (35), and an M10 Nylon Locknut (42).
16.Press a 3/4Ó Round Inner Cap (27) into each end of both Pad Tubes (28). Slide the Pad Tubes through the holes in the Rail Leg (9) and the Leg Lever (10). Slide Foam Pads (30) onto the ends of the Pad Tubes.
17.Press a Handgrip (17) onto each end of the Lat Bar (56).
18.Make sure all parts are properly tightened. The use of the remaining parts will be explained on pages 11 and 12.
14 | 16 |
|
|
| |
| 36 |
|
| 49 |
|
| 42 |
|
| 51 |
|
| 50 |
|
| 18 |
|
15 |
|
|
| 35 |
|
42 | 24 | 19 |
|
| |
| 35 |
|
44 |
|
|
| 9 | 48 |
| 44 | |
|
| |
16 |
|
|
30 |
|
|
| 27 |
|
| 28 |
|
| 27 |
|
| 9 |
|
| 10 | 30 |
|
| |
17 |
|
|
17 |
|
|
| 56 |
|
|
| 17 |
10
