3.Press a 51mm Round Outer Cap (20) onto each end of the Rear Stabilizer (3).
Attach the Rear Stabilizer (3) to the Base (7) using two M10 x 67mm Bolts (48), two M10 Flat Washers (44), and two M10 Nylon Locknuts (42). Make sure the Rear Stabilizer is turned as shown, with the large holes facing up. Do not tighten Nylon
Locknuts yet.
4.Slide the indicated end of the Right Brace (4) into the large hole in the Rear Stabilizer (3). Attach the Right Brace to the Rear Stabilizer using an M10 x 67mm Bolt (48), two M10 Flat Washers (44), and an M10 Nylon Locknut (42). Attach the bracket on the Right Brace to the Frame (1, 2) using two M10 x 42mm Bolts (46), two M10 Flat Washers (44), and two M10 Nylon Locknuts (42).
Attach the Left Brace (5, not shown) to the Rear Stabilizer (3) and the Frame (1, 2) in the same manner.
Tighten all Nylon Locknuts used in steps 1 to 4.
5.Lubricate an M10 x 127mm Bolt (43). Using the Bolt and an M10 Nylon Locknut (42), attach the Rail (8) to the bracket on the Lower Frame (2). Do not over- tighten the Nylon Locknut. The Rail must be able to pivot freely for storage. Slide the Medium Lock Pin (58) through the indicated holes in the Lower Frame and the Rail.
6.Bolt the six Seat Wheels (32) to the inside of the Seat Carriage (11) using six M6 x 33mm Shoulder Bolts (33), six Spacers (60), and six M6 Nylon Locknuts (52). Note: The Wheels may already be attached to the Seat Carriage.
7
3 |
|
|
|
| 20 |
|
|
| 44 | 48 |
|
| 42 |
| 20 |
|
|
| |
| 3 |
|
|
| 7 |
|
|
4 |
|
|
|
| 1 | 46 |
|
2 |
|
| 4 |
|
|
| |
42 |
|
|
|
44 | 46 |
|
|
|
|
| |
| 3 |
|
|
|
|
| 48 |
| 42 | 44 | |
|
|
| |
5 |
|
|
|
| 42 | 2 | 58 |
8 |
|
|
|
|
|
| 43 |
6 |
|
|
|
| 11 |
|
|
52 |
|
|
|
60 |
| 52 |
|
32 |
|
| |
|
|
| |
33 |
|
|
|
| 52 |
|
|
32 | 60 |
|
|
|
|
| |
