Weider WESY26331 user manual Route the Press Cable 88 around the 90mm

39. Note: The 90mm Pulley (82) used in this step	39
was attached in step 38. It is shown removed
for easier part identification.
Route the Press Cable (88) around the 90mm
Pulley (82). Make sure that the Cable Trap (80)			9	42
is turned to hold the Cable in place and that
the Cable is routed as shown. Tighten the M10				82
x 120mm Bolt (74) and the M10 Nylon Locknut				80
(42).
				88
			74
40. Attach the Press Cable (88) to the Front Seat	40
Frame (8) with an M8 x 69mm Shoulder Bolt (43),
an M8 Washer (20), and an M8 Nylon Locknut
(40). Make sure the flat edge of the Cable is			43
against the Seat Frame.
	8		88
	40
	20			Flat
				Edge
41. Identify the High Cable (85)—this is the short-	41
est remaining cable. Wrap the High Cable
around a 90mm Pulley (82). Attach the Pulley to
the Top Frame (2) with an M10 x 92mm Bolt (76),
an M10 Washer (38), and an M10 Nylon Locknut		2
(42). Make sure that the end of the Cable with	38
the ball is on the indicated side of the Pulley
	42
and that the Cable is between the Pulley and
the post.			82
	Post		76
	85
42. Wrap the High Cable (85) around a 90mm Pulley	42
(82). Attach the Pulley and a Cable Trap (80) to
the Top Frame (2) with an M10 x 92mm Bolt (76),	76
an M10 Washer (38), and an M10 Nylon Locknut			38
(42). Make sure that the Cable Trap is posi-
tioned to hold the Cable in place.		2	80
			82	42
			85
	17