Weider WESY26331 user manual End with two Holes should Be down

43.Route the High Cable (85) under a 90mm Pulley (82). Attach the Pulley and a Cable Trap (80) to the single hole end of the Pulley Plates (31) with an M10 x 48mm Bolt (50) and the M10 Nylon Locknut (42). Make sure that the Cable Trap is positioned to hold the Cable in place.

44.Wrap the High Cable (85) around a 90mm Pulley (82). Attach the Pulley to the Top Frame (2) with an M10 x 48mm Bolt (50) and an M10 Nylon Locknut (42). The Cable must be routed from the direction shown.

45.Attach the High Cable (85) to a Small “U”-bracket (32) with an M8 Nylon Locknut (40) and an M8 Washer (20). Do not completely tighten the

Locknut. It should be threaded onto the end of the Cable so that two threads show past the Locknut (see the inset drawing).

Attach the Small “U”-bracket (32) to the indicated Weight Tube (25) with an M8 x 45mm Bolt (68) and an M8 Nylon Locknut (40).

46.Locate the Low Cable (86). Wrap the Low Cable over a 90mm Pulley (82). Attach the Pulley and both Pulley Covers (94) to the Ab Upright (1) with the M10 x 97mm Bolt (95), two M10 Washers (38), and an M10 Nylon Locknut (42). Do not overtighten the Locknut; the Pulley should turn easily. Make sure that the Cable is between the Pulley and the post, and that the Pulley Covers are turned so the wide tabs are on the indicated side.

43
			85	82
		50
End with two				80
holes should				31
be down
44
			42
	2			50
				82
				85
45				85
		32		40
		68		20
				40
32	85			25
	20
	40
46	94
			Post
42		82
38
Wide			94	95
tabs
must be	86			38
on this
side
		1

18