Weider WESY37531 user manual Cable Assembly, Nylon Jamnut the Leg Lever must pivot easily

19.Attach a Bumper (40) to the Press Front Leg (20) with a 1” Tap Screw (80).

Press a 2” x 3” Inner Cap (78) into the top of the Press Leg Lever (90).

Lubricate a 1/2” x 4” Bolt (68). Attach the Press Leg Lever (90) to the Press Base (6) with the Bolt and a 1/2” Nylon Jamnut (36). Note: Do not over tighten the Nylon Jamnut; the Press Leg Lever must be able to pivot easily.

20.Insert two 2” Square Inner Caps (28) into the Leg Lever (41).

Attach a Bumper (40) to the Butterfly Front Leg (3) with a 1” Tap Screw (80).

Lubricate a 3/8” x 3” Bolt (88). Attach the Leg Lever (41), with the small slot on the side shown, to the Butterfly Front Leg (3) with the Bolt and a 3/8” Nylon Jamnut (63). Note: Do not over tighten the

Nylon Jamnut; the Leg Lever must pivot easily.

CABLE ASSEMBLY

21.

IMPORTANT: While assembling the cables, do not over tighten the bolts and nuts attaching the pulleys. The pulleys must be able to turn freely. Refer to the Cable ID Chart on page 26 for help identifying the cables.

Locate and open the parts bags labeled “CABLE ASSEMBLY” and “PULLEYS.”

Locate the Butterfly Cable (73), which is the shorter cable of the two that have eyelets on both ends. Attach the Butterfly Cable (73) to the Right Pivot Arm (85) with a 5/16” x 2 1/4” Shoulder Bolt (79) and a 5/16” Nylon Jamnut (34).

22.Wrap the Butterfly Cable (73) over a “V”-Pulley

(27).Attach the “V”-Pulley and a Large Cable Trap

(32)to the bracket on the Butterfly Upright (1) with a 3/8” x 2 1/2” Bolt (87) and a 3/8” Nylon Locknut

11

19	78
	90
	40
		20
68	80
Lubricate	36	6
20	Lubricate		88
			28
	63		41
			Small
	40		Slot
		80	28
	3
21
	79
73		85
	34
22
		50
87	32
	27
	73	1