16
67
ATTACHINGTHE ACCESSORIES
Toattach a Short Handle (67) to a high pulley, first
attach the high pulley to the resistance system (see
ATTACHING THE HIGH PULLEYS on page 13). Then,
attach the Short Handle to the Short Cable (60) with a
Cable Clip (64).
The Long Handles (not shown) and the Ankle Strap
(not shown) can be attached to the long cable (not
shown) with Cable Clips (64). Attach the Leg Press
Strap (not shown) to both ends of the long cable, or the
Lat Bar (not shown) to the Short Cables (60), with two
Cable Clips.
60
60
64
32
Hook
C
62
64
53
+/–Switch
ATTACHING THE LEG LEVER
To use the Leg Lever (32), attach the two ends of the
Leg Lever Cable (62) to the ends of the long cable(C)
with two Cable Clips (64).
Detach the Leg Lever Cable (62) from the long cable
(C) when the Leg Lever (32) is not in use. Store the
ends of the Leg Lever Cable on the hook under the
Bench Rail (23).
ADJUSTING THE RESISTANCE
To change the resistance setting, press the + / –
switch on the Console (53). The display will show the
current resistance level setting. The resistance can be
increased up to 240 pounds.
Note: While the resistance setting is changing, the
motor will be heard. Toprevent damage to the
motor, do not pull any of the cables while the
resistance setting is changing.
Note: The resistance system uses progressive resist-
ance. As the resistance bar begins to bend, the
amount of resistance will increase gradually. As the
bar bends further, the resistance will increase rapidly.