7.Slide two 5/16Ó Flat Washers (56) onto two 5/16Ó x 1 3/4Ó Bolts (58).
Align the holes in the bracket on the Top Frame (1) with the holes in the Rear Upright (18). Insert the 5/16Ó x 1 3/4Ó Bolts (58) and hand tighten two 5/16Ó Nylon Locknuts (53) onto them.
8.Attach the upper ends of the Weight Guides (23) to the bracket (D) on the Top Frame (1) with two 5/16Ó x 1 1/2Ó Bolts (61) and two 5/16Ó Nylon Locknuts (53). Tighten the Nylon Locknuts, but be careful not to overtighten them since this may damage the weight guides.
9.Press a 1 1/2Ó Square Inner Cap (33) into the end of the Seat Frame (36).
Insert two 5/16Ó x 2 3/4Ó Bolts (67) through the Support Plate (27) and the indicated holes in the Front Upright (42). Place the mounting bracket (E) on the Seat Frame (36) over the two Bolts. Tighten a 5/16Ó Nylon Locknut (53) onto each Bolt.
Tighten all Nylon Locknuts used in steps 3 through 9.
Arm Assembly
10.Locate and open the parts bag labeled ÒARM ASSEMBLY.Ó
Press Arm Assembly. Align the welded spacers on the Press Frame (12) with the tube (F) on the Base
(8). Lubricate the 3/8Ó x 8Ó Bolt (59). Attach the Press Frame to the Base with the Bolt and a 3/8Ó Nylon Locknut (63).
Make sure the welded tab on the Press Frame (12) is oriented as shown.
8
7 |
|
|
|
| 58 | 56 |
|
|
| 1 | |
|
|
| |
|
| 53 |
|
| 18 |
|
|
8 |
| D |
|
|
| 53 | |
|
|
| |
|
|
| 1 |
61 |
|
|
|
23 |
|
|
|
9 | 67 | 42 |
|
|
| ||
|
|
| |
|
| 27 | E |
|
|
| |
|
|
| 53 |
|
|
| 36 |
|
| 53 | 33 |
10 | Welded Tab |
| 12 |
| 63 |
| 59 Lubricate |
F | Welded Spacers |
| |
| 8 |
