11.Press a 2Ó Square Inner Cap (21) into the top end of each Press Arm (46).
Press a 1Ó Round Inner Cap (49) into the indicated hole on each Press Arm (46).
Attach each Press Arm (46) to the Press Frame (12) with two 5/16Ó x 2 3/4Ó Bolts (67) and two 5/16Ó Nylon Locknuts (53).
12.Butterfly Arm Assembly. Identify the Right Arm (48) and the Left Arm (47) by imagining yourself sitting on the seat. Note the position of the welded bracket (G) on each Arm. Arm identification is very important for this step.
Lubricate both axles (H) on the Top Frame (1). Slide the Right Butterfly Arm (48) onto the right axle. Note:
Be careful not to confuse the Right and Left Butterfly Arm. Make sure the upper end of the Right Butterfly Arm is behind the indicated brack- et (I) on the Top Frame.
Tap two 1Ó Retainers (4) and a 1Ó Round Cover Cap
(3) onto the Right Axle. Make sure the teeth on the
Retainers (4) bend towards the Cover Cap (3), as shown in the inset drawing.
Attach the Left Butterfly Arm (47) in the same man- ner. Press a 2Ó Square Inner Cap (21) into each end of the crossbar on the Top Frame (1). Press a 2Ó Square Inner Cap (21) into the lower end of each Butterfly Arm (47, 48).
Lubricate the lower end of each Butterfly Arm with soapy water and slide a Foam Pad (45) onto each Arm.
9
11 |
|
| 21 |
| 46 |
21 |
|
49 |
|
46 | 67 |
| |
| 53 |
| 12 |
12 | 1 |
| |
| 21 |
| I |
| 47 |
H |
|
21 |
|
| G |
| 4 |
| 45 |
| 3 |
| 21 |
| 48 |
| Axle |
45 | 4 |
21 | 3 |
|
