Weider WESY85104 user manual Cable Assembly

CABLE ASSEMBLY

15. Route the Long Cable (23) around the “V”-	15			50	7
Pulley (6) on the Right Arm (48). Be sure
that the Cable is in the groove of the “V”-					6
Pulley and that the Long Cable Trap (50) is
turned to hold the Cable in place. Tighten
the 3/8” x 2 1/2” Bolt (7) and the 3/8” Nylon
Locknut (not shown).
					48
			23
16. Route the Long Cable (23) around the 3 1/2”	16		68	66
Pulley (15) attached to the Pulley Bracket
(20). Be sure that the Cable is in the
groove of the Pulley and that the Cable
Trap (66) is turned to hold the Cable in		20
place. Tighten the 3/8” x 2” Bolt (12) and the
3/8” Nylon Locknut (not shown).		12
Be sure that the 5/16” x 5” Bolt (68) is proper-		23		15
ly tightened and that the Pulley Bracket (20)
can move freely.
17. See the inset drawing. Attach a 3 1/2” Pulley	17
(15) and a Cable Trap (66) to the indicated
hole in the Long “U”-Bracket (57) with a 3/8” x
2” Bolt (12) and a 3/8” Nylon Locknut (21).Be
sure that the Cable Trap is inside the “U”-
Bracket. Note: This may come pre-assem-
bled.		23			23
Route the Long Cable (23) around the 3 1/2”		66	15
Pulley (15) and through the Long “U”-Bracket			12
(57). Be sure that the Cable is in the
		21
groove of the Pulley and that the Cable
		57
and Pulley move smoothly.
18. Note: The Pulley (15) in this drawing is	18				15
pre-assembled. It is shown disassembled				23
for easy part identification.			Bracket		12
Route the Long Cable (23) around the 3 1/2”
Pulley (15) attached to the bracket on the Top			55
Frame (55). Tighten the 3/8” x 2” Bolt (12)
and the 3/8” Nylon Locknut (21).Be sure that
the Cable is in the groove of the Pulley
and that the Cable and Pulley move			21
smoothly.

10