21.Route the Short Cable (58) around the 3 1/2” Pulley (15) attached to the lower hole in the Front Upright (42). See the inset drawing.
Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the 3/8” Nylon Locknut (21) and the 3/8” x 3 3/4” Bolt (71).
22.Route the Short Cable (58) around the 3 1/2” Pulley (15) attached to the upper hole in the Press Frame (17). Be sure that the Cable
Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the 3/8” Nylon Locknut (21) and the 3/8” x 3 1/2” Bolt (not shown).
CABLE ASSEMBLY
23.Route the Short Cable (58) around the 3 1/2” Pulley (15) attached to the upper hole in the Front Upright (42). See the inset drawing.
Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the 3/8” Nylon Locknut (21) and the 3/8” x 3 3/4” Bolt (71).
12
21 |
| 42 |
|
| |
| 42 | 15 |
| 15 | 71 |
|
| 66 |
| 58 | 58 |
21 |
| Inset shows view |
| from other side | |
|
| |
22 |
|
|
|
| 58 |
|
| 15 |
|
| 66 |
|
| 21 |
|
| 17 |
23 | 58 | 42 |
| 15 | |
|
| |
42 | 15 | 71 |
| ||
21 |
| 66 |
|
| 58 |
|
| Inset shows view |
|
| from other side |
