Complete block assembly
Install burner mounting plate on front section
b.Position 3/8" sealing rope in groove.
c.Secure assembly to section. Use
1.Install four ½" x 3½" studs to secure burner mounting plate to section:
a.Thread and lock together two nuts on rounded end of stud. Thread flat end of stud into one of four holes located around opening.
b.Remove nuts.
c.Repeat steps a and b for remaining studs.
2.Repeat above steps for back observation port as- sembly.
Insert HXT-bars
1. See Figure 12, page 12.
2.Install burner mounting plate:
a.Apply 1/8" continuous bead of sealing rope adhesive in groove around opening in section.
b.Position ½" sealing rope in groove. Overlap ends at least one inch.
c.Install burner mounting plate with part number and the word, "UP," positioned at top. Use ½" washers and nuts.
Install observation port assemblies on front and back sections
1.Install front observation port assembly:
a.Apply 1/8" continuous bead of sealing rope adhesive in groove on observation port.
2.Flue
•Top position
•
•Middle position
•
•Bottom position
•
Figure 12 Insert
12 | Part No. |