NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for proper operation.
Refer to SHIPPING DAMAGE CLAIM PROCEDURE on the inside front cover of this manual.
WARNING:
RISK OF INJURY
Installation procedures must be performed by a qualified technician with full knowledge of all applicable electrical and plumbing codes. Failure can result in personal injury and property damage.
CAUTION
FIRE HAZARD
Avoid storing flammable or combustible materials in, on or near the appliance.
CAUTION
SHOCK HAZARD
The ground prong of the electrical cord is part of a system designed to protect you from electrical shock. In the event of internal damage to the warmer. NEVER CUT OFF THE GROUND PRONG (large round prong). NEVER TWIST AND ELECTRICAL PRONG TO FIT AN EXISTING RECEPTACLE. Install an electrical circuit and/ or receptacle appropriate to the voltage/amperage requirements of the appliance.
IMPORTANT: Damage due to being plugged into wrong voltage is NOT covered by warranty.
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all protective plastic film, packing materials and accessories from the Appliance before connecting electrical power or otherwise performing any installation procedure.
Carefully read all instructions in this manual and the Installation Instruction Sheet packed with the appliance before starting any installation.
Read and understand all labels and diagrams attached to the appliance.
Carefully account for all components and accessories before discarding packing materials. Store all accessories in a convenient place for later use.
SET-UP NOTES
1.Setup the appliance only on a firm, level,
2.Adjustable legs:
a.Install one adjustable leg at each corner of the appliance by screwing the leg into the fitting on the bottom. With a spirit level, check that the appliance is level
b.The lower portions of the legs are adjustable by turning; adjust as required to level the appliance. All four legs must be adjusted to firmly contact the counter in order to prevent tipping.
3.Avoid storing flammable or combustible materials in, on or near the appliance.
ELECTRICAL HOOK-UP
1.Refer to the nameplate. Verify the electrical service power. Voltage and phase must match the nameplate specifications. Plugging the warmer into the wrong voltage can severely damage the unit or cause noticeable decreased performance.
2.Your warmers is equipped with a grounded electrical cord. This cord must be plugging into a properly grounded electrical receptacle.
004 p/n 305145 OpM
4
