INSTALLATION (continued)
M707 p/n 306692 OpManual
ELECTRICAL INSTALLATION
NOTICE:
A DEDICATED CIRCUIT OF AT LEAST 40 AMPS IS REQUIRED.
WIRING AND CONNECTIONS MUST BE INSTALLED AND
MAINTAINED IN COMPLIANCE WITH
FEDERAL, STATE, AND LOCAL ORDINANCES.
The dispenser is factory configured for either 208 volts or 240 volts. The voltage configuration is NOT field convertible.
DO NOT connect unit to electric power until water supply is connected and turned on.
Be sure HEATER SWITCH is OFF (O) before connecting unit to electric power.
CAUTION:
SHOCK HAZARD
Removal of any exterior panel will result in exposed electrical circuits. Electrical connection must be performed by a
qualified technician only. Use care whenever working around exposed electrical circuits.
IMPORTANT:
Contact a licensed electrician co connect electric power to the dispenser.
IMPORTANT: Damage due to being connected to the wrong voltage or phase is NOT covered by warranty.
IMPORTANT: Supply voltage must correspond to the nameplate voltage of the unit. Connection to the wrong voltage can result in equipment damage or reduced performance.
Such damage is not covered by warranty.
7