INSTALLATION (continued)
CAUTION:
RISK OF DAMAGE
DO NOT connect or energize this appliance until all Installation Instructions are read and followed. Damage to the dispenser will occur if these instructions are not followed.
IMPORTANT: Water supply MUST be a minimum of 1/4” line, and MUST be capable of supplying 25 p.s.i. AT ALL TIMES during the operation of the dispenser.
PLUMBING LINE CONNECTION
If power has been run to the dispenser, verify that the circuit breaker is turned OFF, and that the POWER SWITCH is in the OFF [O] position.
NOTICE:
WATER PIPE CONNECTIONS AND FIXTURES DIRECTLY
CONNECTED TO A POTABLE WATER SUPPLY SHALL BE SIZED, INSTALLED AND MAINTAINED ACCORDING TO FEDERAL, STATE, AND LOCAL ORDINANCES.
Minimum 1/4” copper or flex tubing supply line (3/8” minimum if run from main supply exceeds 12 feet) with 1/4” female flare fitting.
Minimum 25 psi / maximum 75 psi water pressure at full flow.
The installation of a SHUTOFF VALVE (must be provided by plumbing installer) on the incoming water line is required. A 1/4 turn ball valve is recommended to minimize restricting the water flow during operation.
Installation of a PRESSURE REGULATOR and WATER HAMMER ARRESTOR (to be provided by plumbing installer) on the incoming water line is recommended.
Clean the incoming waterline: Run water through the line into a sink or bucket to flush any foreign particles or debris from the waterline.
Assemble incoming water line to the inlet fitting. Turn on water supply valve and check for leaks.
If a pressure regulator is installed, adjust pressure to 40 p.s.i.
M707 p/n
Fig. 3 1/4 Turn Ball Valve
306692 OpManual
6